List of Contributions

Hello, Have you double checked your Chassis Size under the properties in the AOP? ------------------------------ Amir Pedram ------------------------------

Hello, Under the Axis Properties, go to the parameter list and look for "SoftTravelLimitChecking" - Yes. For some reason your checkmark is greyed out. See the example below: ------------------------------ Amir Pedram ------------------------------

Safety task is inoperable. This fault occurs when the safety logic is invalid, for example a mismatch in logic exists between the primary controller and safety partner, a watchdog timeout occurred, or memory is corrupt. Clear the fault. If a safety task signature exists, safety memory is re-initialized ...

If you exit the factory talk software on the HMI and get into the Windows CE you can change pictures and the timing of the screen saver there.

Run the MAOC Position Reference on Actual Position. When e gearing or camming to a Virtual Axis, I always use Actual.

If you're using Factorytalk Linx 6.3, this is a known issue that Rockwell is currently working on. Quick fix for now is to uninstall version 6.3 and install 6.2.

It really depends on which processor you're running. I'm assuming since it's a KN6000, it's running on Sercos Interface with possibly an 5570 or 5560 series. Studio5000 Logix designer Revision 24 is very stable.

Is it a linear axis or rotary? What are your maximum and minimum travel limits in the axis settings.