List of Contributions

It doesn't stay on long enough to switch modes. It also doesn't stay on long enough to upgrade the firmware. It previously worked fine before. ------------------------------ Ryan G. ------------------------------

I have a Micrologix 1100 1763-L16AWA and whenever power is applied to it, the screen and everything loads like it is supposed to but then it reboots as if the power was removed and re-applied. It continues in this cycle until power is actually removed. I have all of the correct voltages. Anybody have ...

I tried bootp like in the video and bootp found the device but when I created an Ethernet/IP driver in Rslinx it didn't find my PLC. When I manually put an IP address in on rslogix 500 and then create an ethernet driver in Rslinx, it says unrecognized device and then a red X shows up. ----------- ...

I also tried restarting the PLC and it didn't change anything. ------------------------------ Ryan G. ------------------------------

I did go online with RS232 to manually set the IP address and it was showing the IP address in the ethernet config section in the PLC. I then tried to ping the IP address and it was not found. Neither of the indicators on the ethernet port light up and I have connected with other Ethernet/IP devices ...

Hello, I have a Micrologix 1100 and the Comm1 indicator is always solid and I can't communicate with the PLC through ethernet. I tried cycling power, different cables and even doing a firmware update and nothing worked. Everything else on the PLC seems to be working and I can connect with RS232 just ...

Hello, I have a Micrologix 1100 BWA controller and the 24vdc output terminals at the top left of the controller only show 23.5 volts when I measure with my multimeter. Does anyone else have one of these controllers that can let me know what voltage they are seeing? Is there a certain tolerance on ...

Hello, I have a 1764-LSP processor and when I installed it in the Micrologix 1500 base unit I noticed the power, fault, and force leds were flashing. I tried flashing a newer firmware with ControlFlash but it failed and now the fault led is lit solid red. Does anyone know how to fix this issue or ...