List of Contributions

Hello, I'd like to share a very similar experience-though in my case, it involved the 5700 family and a ControlLogix L83ES controller. The machine-supplied by a German vendor-was running very well; however, just like you, I encountered an issue where it would fail on only two or three cycles throughout ...

Thanks @Batman Another question, I would like to simulate, in my company we have an encoder to start implementing it. I will use the value from the web machine's encoder to measure the tubes and be able to simulate it, is it possible to simulate the axes? Should I take them as virtual axes to ...

Thanks for the information, but I have already configured that parameter as active. Let me restructure my question: What would be the parameter to indicate a failure to the VFD if it gets stuck or my encoder loses mechanical coupling (something that compares the motor speed vs. the encoder rotation ...

Dear community I need your help This my first time this forum (excuses if I'm rude) I add Powerflex 755TS buy i don't see the parameter when the encoder doesn't count, mean the motor stall. Cause configured loss signals of encoder. Thanks so much for your support. ---------------------- ...