List of Contributions

So, I tried the "From PLC to Model" library - a really great extension! It created the object exactly the way I wanted, and I was very pleasantly surprised. However, while the objects were created and automatically linked to the correct PLC variables, there seems to be an issue: the value inside the ...

I have one additional question. Since none of the approaches we've tried so far have been successful, I wanted to go the extra "kilometer" and create the object manually, as you recommended. However, as you already know, we're dealing with nested STRUCTs. When I try to replicate that structure using ...

That's actually very nice, it's great to see the structure on the left-hand side. Thank you for the tip! I created a first example following your approach and then mapped the previously mentioned variable emExampleError.cmDolMotor.stHmiDOL.bStatusThermalProt to the corresponding PLC variable. However, ...

At first, based on your initial answer : "I will lick on anything even when I'm 100% sure it's not safe" I didn't notice the pun right away. I only caught it after reading it again. 😄 As promised, here's the example attached to this post: two variables in the Modelling section share the same ...

Thank you ! I will prepare everything and will come back to you probably Tuesday :) -------------------------------------------

Thank you asemlucben ! That was faster than I expected! For 1: Understood, thank you. For 2: I don't fully agree that this situation falls back into case 1. For me, these are two completely different patterns, since I'm not mapping entire structures. As shown in the image above, I am only mapping ...

Hey everyone, short disclaimer: I am from Germany and usually working inside the Beckhoff environment, so please excuse my typos/grammar or "beginner" questions. We are currently running a setup where we are controlling a machine based on location either w/ a Beckhoff or an AB Control, in both cases ...