List of Contributions

I think that I'm going to upgrade to version V35, Thanks, everyone!! ------------------------------ Fernando Larraga ------------------------------

In this case, I'd like to inquire about the safety of downgrading the firmware. If I proceed with the firmware update (downgrade), is there any risk of losing the program that is currently stored in the controller? I want to ensure that the program remains intact during this process. Thank you very ...

Hello everyone, I'm facing an issue while trying to go online with a PLC. The firmware revision of the controller is 34.011, but the offline project I have is showing a firmware revision of 33.xx. Due to this mismatch, I'm unable to establish a connection. I'm relatively new to this company and recently ...

EDIT: moved to Legacy community -FL Hello everyone I'm reaching out to seek your insights and expertise regarding a challenge I'm facing with a recently acquired plant. The plant utilizes a MicroLogix 1200 PLC to control a HighService water system, and I'm encountering difficulties in establishing ...

Philip Hamilton Thank you for your response and the detailed information about building control panels. I found your breakdown of the design and assembly aspects very helpful. Considering the different aspects involved, I'm particularly interested in learning about the assembly process of building ...

Hello everyone, I'm seeking recommendations for training programs or resources focused on building control panels. I have a basic understanding but want to enhance my skills in design, wiring, components, safety, and troubleshooting. If you have attended any reputable hands-on training programs ...

Hello, Thank you for your response and for providing valuable insights into the possible causes of the configuration issue. I greatly appreciate your help and expertise. I have successfully resolved the configuration issue. After thorough troubleshooting and confirming the module profile ...

Hello everyone, I'm seeking some guidance and assistance regarding an issue I've encountered while configuring a Proline Promag W 400 flow meter module in Logix Designer. I'm experiencing the following error: Error Code: 16#0009 Fault Additional Code: 16#0000 Fault Description: Module Configuration ...